Emergency Light Bars /  Fire and EMS

Fire Truck Light Bars

Red and white light bars for fire trucks, chief and command vehicles, ambulances, brush trucks and fire police. Low Pro bars from 17 to 68 inches, SAE Class 1 certified, IP69K sealed.

  • SAE Class 1J845 and J595 certified
  • IP69KSealed housing
  • 17 to 68 inLow Pro lengths
Black Oak Low Pro red and white emergency light bar on a fire truck

Before you buy

Is it certified for emergency use?Yes. Low Pro bars are certified to SAE J845 and SAE J595 Class 1, the intensity class for primary emergency vehicles.
How does it mount?Door jamb straps with no drilling, bolt-on headache rack brackets, or magnet feet on the 17 inch bar.

Shop by size

Black Oak 17 inch Low Pro red and white emergency light bar17 InchBlack Oak 30 inch Low Pro red and white emergency light bar30 InchBlack Oak 43 inch Low Pro red and white emergency light bar43 InchBlack Oak 49 inch Low Pro red and white emergency light bar49 InchBlack Oak 55 inch Low Pro red and white emergency light bar55 InchBlack Oak 61 inch Low Pro red and white emergency light bar61 InchBlack Oak 68 inch Low Pro red and white emergency light bar68 Inch

Shop by color

Amber Light BarsAmber Light BarsTow Truck Light BarsTow Truck Light BarsPolice Light BarsPolice Light BarsAll Emergency BarsAll Emergency Bars

Fire & EMS Light Bars

Red and white light bars for fire trucks, chief and command vehicles, ambulances, brush trucks and fire police.

Available in 17 through 68 inch red and white configurations.
Filter Filter
Reset

Filter

Filter

10 products

Remove all

10 products

Fire & EMS Light Bars

Red and white LED light bars for engines, ladders, rescue units, ambulances and volunteer privately owned vehicles. Every light bar on this page is available in a Red & White configuration, uses Generation IV LEDs behind TIR optics, and is sealed to IP69K so it holds up to hose-down washing, foam residue and years of outdoor apparatus storage.

What size light bar for fire and EMS apparatus?

Apparatus cabs and ambulance boxes are wider than patrol vehicles, so fire and EMS builds skew toward the long bars. Volunteer POVs are the opposite case, where a 17" or 30" on a magnetic mount is usually the right answer.

Low Pro fire and EMS light bar sizing
Size Typical application Mounting
17" Volunteer POV, chief's vehicle dash or deck Magnet or headache rack
30" Volunteer POV roofline, utility and brush truck Door jamb, magnet or headache rack
43" Command vehicle, mid-size SUV Door jamb or headache rack
49" Ambulance cab, full-size command SUV Door jamb or headache rack
55" Rescue and squad body, full-width pickup Door jamb or 4x headache rack
61" and 68" Engine and ladder cab roofs, full apparatus width Door jamb or 4x headache rack

Color law for fire and EMS

Red is the near-universal fire and EMS color in the United States, and red combined with white is standard on apparatus. The restriction that catches people out is the volunteer POV: many states allow a volunteer firefighter to run red or blue on a personal vehicle only with a department-issued permit, and a handful assign blue to volunteers and reserve red for the apparatus itself. Verify your state code and your department's standard operating guideline before you order.

Built for apparatus duty

  • Generation IV LEDs with TIR optics, 1.5" profile, no reflector housing to trap water
  • 13 selectable flash patterns with memory, plus steady-burn scene mode
  • IP69K sealed aluminum extrusion rated for direct high-pressure washing
  • Independent left, center and right sections for traffic advisor and blocking patterns
  • 61" and 68" models include rear-facing tow-package sections for scene protection
  • 12', 22' and 27' controller cable options for long apparatus runs

Planning an apparatus or POV build? The emergency light bar buying guide covers sizing and mounting, and amber warning light laws by state covers the color rules for support and volunteer vehicles.

Back to all emergency light bars

Red and white fire and EMS light bars by size

Every link below opens the bar with the red and white configuration already selected.

17" to 43" red and white light bars

POV response, brush trucks and chief vehicles: 17", 30" and 43" in red and white.

49" and 55" red and white light bars

Chief SUVs, squads and ambulances: 49" and 55" in red and white.

61" and 68" red and white light bars

Full-width apparatus bodies and rack mounts: 61" and 68" in red and white.

Fire truck light bar questions

Who runs red and white light bars?

Fire apparatus, EMS units, brush trucks and chief or POV response vehicles where department policy and state statute allow red. Confirm your state's rules for personally owned vehicles before ordering.

Can the bar run all red or all white?

Yes. Every module runs either ordered color at full output: all red for response, all white for scene light, plus alternating and zoned modes across 24 flash patterns.

What size fits fire apparatus?

Full-width bodies take the rack-mounted 61" or 68". Chief SUVs and squads usually land on the 49" or 55".